STIHL / Viking Haubensensor-Platine 6309 430 5235
NEW
SOLD OUT

STIHL / Viking Haubensensor-Platine 6309 430 5235

Product No.:
63094305235B
ca. 3-4 days ca. 3-4 days (abroad may vary)
21,32 EUR

incl. 8.1% tax excl. Shipping costs

Add to wish list
Ask about product
Description

STIHL / Viking Hood Sensor PCB 6309 430 5235

This used and tested sensor PCB is intended for the 632 iMow series and is mounted in the front upper housing area. It fits version-dependent MI 632 and RMI 632 models and helps with loop signal and hood sensor related faults.

  • Original part for Viking MI 632, MI 632 C and Stihl iMow RMI 632, RMI 632 P, RMI 632 PC and RMI 632 C
  • Half-round encapsulated design for improved moisture protection
  • Used and tested, fully functional
  • Documented predecessor 6309 430 5227 and documented successor 6309 430 5237
  • Scope of delivery: 1 x PCB without additional mounting parts

Technical

  • Product type: PCB (hood sensor)
  • Function: front sensor electronics for loop signal and hood sensing
  • Design: half-round and encapsulated
  • Connection: plug connection
  • Condition: used and tested

Installation

The PCB is mounted at the front under the upper housing. Before replacing it, compare the old part number, connector layout and mower version.

During installation, make sure the connectors are clean and the board sits properly so the sensor system works reliably.

  • Check mower type and PCB marking before ordering
  • Inspect connector and wiring loom for corrosion or broken wires
  • If moisture damage is visible, also inspect seals and housing surfaces

Compatibility

ModellPassende Artikelnummern/MPNErsetzt (belegt)Hinweis/Version
  • Viking MI 632
  • Viking MI 632 C
  • Stihl iMow RMI 632
  • Stihl iMow RMI 632 P
  • Stihl iMow RMI 632 PC
  • Stihl iMow RMI 632 C
6309-430-5235-B, 63094305235B, 6309 430 5235 B, 6309-430-5235, 63094305235, 6309 430 5235, 6309-430-5227, 63094305227, 6309 430 5227, 6309-430-5236, 63094305236, 6309 430 5236, 6309-430-5237, 63094305237, 6309 430 52376309 430 52275237 documented as successor, 5236 and 5237 listed in exploded diagrams as later versions

Important: Please compare part number, mower version and connector type before purchase, because the 632 series may use different PCB revisions depending on version.



• Original hood/front sensor PCB for the 632 iMow series
• Half-round encapsulated design for the front section
• Used and tested, fully functional
• Documented predecessor 6309 430 5227 and documented successor 6309 430 5237
• Scope of delivery: 1 x PCB without additional mounting parts